Ask Experts Questions for FREE Help !
Ask
    Tommy Mac's Avatar
    Tommy Mac Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jun 17, 2009, 09:54 AM
    Removing Engine Drive Pulley from B&S 14HP
    I have a Snapper LT140H38ABV 38" 14 HP Hydro Drive Tractor Series A with B&S 14hp motor Model# 287707-0228-01. I want to replaced the engine crankcase gasket as it has a serious leak. How do I remove the dual belt pulley from crankshaft ? I've removed the bolt from the end of the shaft but it seem to be frozen on. Is the a special puller needed ? Any suggestion would appreciated
    Hot Corn Bread's Avatar
    Hot Corn Bread Posts: 70, Reputation: 3
    Junior Member
    		  
    #2

    Jun 17, 2009, 05:19 PM
    Look fer it! See if there is a keyway slot in the motor shaft above where you removed the bolt. Spray with wd40. You will need a pully pulley. Auto zone will sell you a loaner and refund your money when you return it.
    Tommy Mac's Avatar
    Tommy Mac Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Jun 18, 2009, 08:13 AM

    Had a puller at home, let wd4 set overnight add some heat and smacked the puller with a big hammer off she popped...
    Thanks You
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

B&S pulley removing [ 1 Answers ]

Have a b&s 12 hp old model need to place engine. Have to use the pulleies on the new one to make it work. Any ideas on how to remove them off the shaft and on the newer one.

Craftsman rear engine riding mower drive belt pulley alignment [ 1 Answers ]

The drive belt that propels the machine keeps coming off the idler pulley. It appears that the idler pulley is positioned we below the other two pulleys. Is there a way to move the idler pulley up so it aligns with the others.

Changing Engine Pulley? [ 5 Answers ]

I have Sears riding Lawn Mower with Brides & Stratton engine and it's engine pulley broke off. There are two pulleys attached to this shaft. How to remove and replace this shaft? It's attached to the engine. Thanks.

Removing MTD engine pulley [ 3 Answers ]

I need to replace my drive belt but cannot get the pulley off, motor spins? Any suggestions? Also it is reverse thread correct? Thank You

MTD Engine Pulley replacement [ 2 Answers ]

I've got an old ('89) MTD lawn tractor with a 12hp B&S engine, 38" cut. The engine drive pulley has come apart and needs to be replaced. I can find replacements, but my question is how does the old pulley come off? It seems like there is a nut holding it on. Normal or reverse threaded? How do I...

View more questions Search