Ask Experts Questions for FREE Help !
Ask
    Filip's Avatar
    Filip Posts: 1, Reputation: 1
    New Member
     
    #1

    May 11, 2008, 11:26 AM
    Craftsman Lawn Tractor
    I have a Craftsman lawn tractor Mod. 917-275684. 24hp 42". When I try to start it,the starter turns but does not engage the flywheel. I have a new battery, starter, and solenoid.Please advise.
    captaingary76's Avatar
    captaingary76 Posts: 4, Reputation: 1
    New Member
     
    #2

    May 11, 2008, 11:43 AM
    Hello. Well, I just put a new starter on my 20hp B&S. The littlegear is supposed to pop up when the starter spins and engage the teeth on the flywheel. Try spraying a little WD40 on the shaft and see if the little gear pops up. Otherwise, the gear is really stuck on the shaft and you might have to exchange the starter as defective.

    Good luck! Do you know anything about hunting and surging problems?
    lawnman14's Avatar
    lawnman14 Posts: 37, Reputation: 0
    Junior Member
     
    #3

    May 12, 2008, 09:56 AM
    The little gear not poping up is not the problem. I have the same problem with one of my mowers at home and some of the teeth on the flywheel are gone so it did not engage with the flywheel. To check if this is the problem I believe there are 1/2" bolts on the cover that covers the flywheel so no one gets hurt take that off and look at the flywheels teeth

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Craftsman Lawn Tractor [ 1 Answers ]

I have a used Craftsman Lawn Tractor. Last summer it worked fine. Now, when I am cutting the grass, it shuts off. It will idle without the blades engaged. As soon as I put it in gear or engage the blades, it shuts off. I have replaced the inline fuel filter and it has fresh fuel in it. Any...

Craftsman Lawn Tractor [ 3 Answers ]

How much trouble is it to change the drive belt on a 15.5hp Sears Lawn Tractor? Seems like the speed of this lawn tractor has slowed down. I am assuming that the drive belt could possibly be stretched. Any onther ideas?

Craftsman Lawn Tractor [ 7 Answers ]

I have a Craftsman Lawn Tractor model no. 917.272751. I have put new belts,blades,spark plug,gas filter,air filter,battery, solenoid and 3 new starters. It will not start. If I keep trying to start it burns the starter up. If I hand turn the motor backward a few times it will start right up. ...

Craftsman lawn tractor [ 1 Answers ]

My craftsman 15.5 ohv mo#28n787 . Oil from engine is being pumped into carburator through oil breather tube what can I do to fix this .

Craftsman 16.5 Lawn Tractor [ 1 Answers ]

I have recently replaced the mower clutch cable on my 16.5 HP Craftsman LT1000 lawn tractor with a 42" deck. After doing so, the transmission to the tractor will not engage. All the belts seem to be in place. I did not replace the clutch carriage bolt yet, as indicated by the instructions, after...


View more questions Search