Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Chainsaw mack 1516 won't start
[ 2 Answers ]
I bought a mack 3516 chainsaw at the yard sale, it started right up and ran for 15 seconds or so, took it home started up and ran a few seconds and stopped, never started again, I noticed no gas in the bubble, took the top off and seen the gas hoses were rotted and leaking bad, I put on new...
Hard to start and pull craftsman chainsaw
[ 1 Answers ]
Craftsman chainsaw used twice been in storage for 7 years went to use and pulling to start is difficult sometimes stopping in mid pull very hard on hands
Stihl Chainsaw MS-250 Pull-Start issue
[ 2 Answers ]
Hi I have a 48cc Stihl chainsaw ms-250. The pull start on it is really hard to pull and it can't start it. It worked fine 2 weeks ago but my grandpa fidled with it (alzeimers) and now it won't work. I can make it turn but it is super hard to do. Yet I can't make it turn fast enough to start. I...
Mcculloch 3516 Primer and Fuel line.
[ 2 Answers ]
Dragged out the chain saw and fuel lines fell apart, can't tell where lines originally went. The way I have it is, from fuel filter pickup into top fitting on carb, out of bottom fitting on carb to short nipple on prime bulb, then from long nipple on primer bulb back into Tank, The way I...
Can't start my Poulan chainsaw. Start rope too hard to pull.
[ 1 Answers ]
Can't start my chainsaw because the start rope is too hard to pull out. Pulling the rope causes a jerky action. View more questions Search
|