Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Leaking hot water heater drain valve after new brass valve installed
[ 2 Answers ]
I had a leaking (plastic) drain valve on my GE hot water heater. It was leaking from the inside of the valve. The small rubber washer was crimped. I installed a new brass drain valve that I purchased from home depot using teflon tape. The valve now leaks from the threads of the tank/valve. I...
I have a early 90's Kohler shower valve and rounded out the cold stem valve seat.
[ 2 Answers ]
Should I drill then retap the threads? Thanks!
I'd like to install a ball valve on main water line will a "Viperlok" valve work?
[ 1 Answers ]
I know sweat soldering a ball valve is best, but will a "push-ft" compression "Viperlok" brand ball valve work?---My pipes are old copper, and have a few minor scratches and pits---I also noticed a seam running down one side of pipe. This water line runs out into garden, but valve is in the house....
What is a tempering valve
[ 2 Answers ]
What is a tempering valve
Leaking tempering valve
[ 0 Answers ]
Cold water leaking from hot water cylinder overflow pipe View more questions Search
|