Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
How do I replace the thermocoupler in a coleman furnace model #7680c586
[ 0 Answers ]
Can't figure out how to get to it
Tempstar Model END4X24C14A2
[ 1 Answers ]
When I turn the thermostat up the furnace turns on and it ignites for about 30 seconds and then turns off. I get 4 flashing lights and if I turn the switch off and then back on it runs again for about 30 seconds and once again turns off and flashes the 4 green lights. If I leave it alone it will...
Tempstar model ntc6075fba1
[ 0 Answers ]
I have a tempstar model furnace NTC6075FBA1. My consultant explained that I need to replace the reduce draft motor. When we turn on the heat switch, nothing happens and the fan is stuck. What am I looking at as far as price for replacing this motor?
Tempstar model #PGF048K080A / No heat.
[ 0 Answers ]
I have a Tempstar model# PGF048K080A tried to turn on the heater and no heat. So I inspected the unit & found the pressure switch was burned out. Replaced the pressure switch & still no heat. Now I believe the draft inducer motor is also burned out. I put my ohms meter on the inducer motor and get...
Clean tempstar flame sensor
[ 1 Answers ]
I have a Tempstar model # nugk100dh08 furnace. I am trying to clean off the end of the flame sensor. Do I need to take the ignitor/sensor unit off? If so, I see that it has 2 screws on top of the unit. Do I just remove those and it drops down so I can clean? The problem I was having was the flame... View more questions Search
|