Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Carrier Gas Furnace, Pressure Switch Problems (Model 58MCA) CODE 31
[ 5 Answers ]
I have tried almost everything in my arsenal to try and diagnose the problem. First off I have a Carrier Gas Furnace that is almost 7 years old. Model 58MCA-80 (See attached photo for more information), with pressure switch #HK06NB123. Intermittently I get a Red Flashing Code #31 when the unit...
Carrier furnace: limit switch fault furnace has ignition but blower will not come on?
[ 2 Answers ]
Board says it is a limit switch fault Furace goes into pre ignition, fan comes on and sometimes even the main burner ignites, but the blower will not come on... is this the blower motor or could this be a switch somewhere?
Low pressure switch are carrier heat pump
[ 0 Answers ]
Well a low pressure switch.. turn off the a Carrier Heat Pump... if the pressure is too low, preventing the Fan to start?
Pressure switch not closing on carrier weathermaker 8000?
[ 1 Answers ]
I have a weathermaker 8000 (carrier)... a few nights ago, I noticed that it was blowing cold air... went down, looked at the furnace, and found that the gas wasn't lighting (so no heat). A little further looking and I found the exhaust pipe had broken off--one section had caved in/fallen apart. I...
Carrier Pressure Switch
[ 4 Answers ]
I have a Carrier 8000 furnace. The furnace will run fine for days or even weeks at a time, and then the code comes on that the pressure switch is stuck open. I can flip the breaker off then back on again and the furnace will work fine for awhile, and then start giving the same code. Any help would... View more questions Search
|