Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Flame Sensor
[ 2 Answers ]
I have a RHEEM furnace with a hot surface ignitor. The flame sensor will only register .01 microamps, not enough to keep the burners fired. What is the procedure for checking polarity for the furnace, and what could other possible causes be? The flame sensor is new, and the gas pressure is 3.5...
Bad Flame Sensor?
[ 1 Answers ]
Thermostat calls for heat Blower comes on for 30 seconds Ignitor glows Gas kicks on & gas ignites in first burner Travels down the to the other three burners including the last one where the flame sensor resides Furnace stays lit for a few seconds and then goes out with a lockout code The...
Flame sensor
[ 1 Answers ]
I have a York Diamond 80 upflow furnace. I think my flame sensor is bad. I checked my wire to the sensor with my meter ( I just completed classes in HVAC) and got 90 on the volts. Just wanted to make sure I am replacing the right part. The flame kicks on and goes out about 5-10 seconds later.
Flame Sensor
[ 5 Answers ]
How can I replace a flame sensor in a Trane heating unit?
Flame sensor questions
[ 3 Answers ]
I have a Goodman gmp125-4 gas furnace. I've been having all sorts of problems recently. I've fixed most of them, but the last problem I had was a code 5 "false flame sensed". The chart inside the door said the most likely problem was a stuck gas valve. I assume this is the problem if the fire... View more questions Search
|