Ask Experts Questions for FREE Help !
Ask
    Alrydu's Avatar
    Alrydu Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jul 29, 2009, 09:40 AM
    Above ground pool sections
    The skimmer section of my above ground pool is badly rusted. Can you purchase this section separately?:confused:
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Jul 29, 2009, 10:10 AM

    It is usually one long roll of aluminum or steel that makes up the side walls , so no. Treat it like a rusty car, sand, primer and paint or scab in a new piece of aluminum.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Leveling the ground with mulch for above ground pool [ 3 Answers ]

I was wondering if I could use mulch to level the ground for my above ground pool. I was told not to use sand, and I have a hard time digging.

Ground setup for above ground pool [ 1 Answers ]

Do I go out further than pool size and how much do I dig out and how much sand do I use it's a 24 ft pool

Water behind a pool liner of an above ground pool [ 1 Answers ]

Hello, the liner in part of my pool is below the water level and thus water is now behind the liner. I cannot pick up the liner because it is so heavy with the weight of the water. 1. Is this hurting my pool 2. How much to replace a new liner and have it installed for a 16ft round pool ...

Leveling ground for an above ground pool [ 2 Answers ]

I spoke to a pool company and they said that when installing an above ground pool you should "dish" the ground in the middle. This meaning that you make the ground in the middle of the pool 3 to 12 inches deeper than the rest of the ground. Everyone else that I have spoken to has said to level the...

Install New Pool Liner-Above Ground Pool [ 1 Answers ]

We are going to install a new liner in an above ground pool this weekend. I have read conflicting information as to when the skimmer and jet holes should be cut. Do you fill the pool with water within a foot of the skimmer, attach the trim kit and then cut out the liner? I don't know what to do,...

View more questions Search