Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Bad Furnace Control Board?
[ 6 Answers ]
I have a Carrier 58PAV that intermittently aborts or sometimes clicks on and off at the draft blower stage. I found out I can move the control board (HK42FZ007) when the blower motor clicks off, and it clicks and comes right back on. If I hold it just right, the furnace starts and if I manage to...
Furnace control board
[ 2 Answers ]
Can the board be repaired or do I need to replace it
Power to furnace control board but stops there
[ 3 Answers ]
Hi I was given a Nordyne KG6RA gas furnace. After installing, I turned on and there was a low hum when the power got to it. I held the door switch closed so I could see. After a few seconds there was a spark and then blue smoke and everything went dead. I could not see where the smoke came...
Wiring question for new blower control board
[ 1 Answers ]
Just bought the Lennox blower control board replacement kit - 31M73 I'm stuck on wiring the transformer--- The five wires coming out of the transformer going to the old board are - Yellow - common Blue - 24 vac Orange-L2 XFMER Primary Black - L1 XFMER Primary Red - PARK
Powering the G terminal on my furnace control board
[ 1 Answers ]
Hi! My furnace's control board recently blew and the repair guy replaced it with a different kind. Aparently the new board requires a wire from the thermostat to the G terminal to work the A/C fan, and the old one didn't. The repair guy would need to make another trip for this repair. I am... View more questions Search
|