Not your question?
Ask your question
View similar questions
Check out some similar questions!
Broke off copper pipe
[ 4 Answers ]
I was trying to replace a bathtub faucet and broke off the copper pipe at the wall is there a way to fix the pipe without calling a plummer or soldering?
Copper pipe in the slab
[ 5 Answers ]
In moving our kitchen to another part of the house, I discovered (after removing the old floor cabinets) that the plumbing seems rather "unusual". The 3/4" lines comes out of the floor (slab) to go up to the old sink, but then cross over above the slab about a foot before then going down again...
PVC to Copper Pipe
[ 3 Answers ]
I am remodeling a bathroom. The existing drain pipe is 1 1/2" copper tubing. What is the best way to connect a 1 1/2" PVC to 1 1/2" copper tubing?
Bathroom sink wall pipe drain pipe
[ 2 Answers ]
My house was built in early 70's.. No plastic.. I'm putting in a new sink and had to remove the wall pipe that goes into the wall.. I needed a longer one. It seem where it goes in behind the wall into the plumbing there was some type of gasket as pieces of it fell out when I removed the pipe.. I...
How to disconnect copper elbo from wall feed PVC
[ 3 Answers ]
I am installing a new water softener. If I could rotate the existing copper elbow feed, for old softener, it would make the new installation much neater. How can I rotate an elbow connected into PVC that has a clamp? View more questions Search
|